Introduction to aluminum liner for oil return pipe:

1. The inlet and outlet hoses are broken. When the rupture is not big, can be coated with a layer of soap cloth will be a good water bandage; If the rupture is large, can be cut off the hose rupture, in the middle of a bamboo tube or iron pipe, and wire binding.

2. The fan belt is broken. The broken belt can be tied up with wire or use stop-start method to drive away.

3. Screw hole slide buckle. Screw hole slide buckle will cause oil leakage or loose connecting rod, making it unable to work. At this time, the original screw can be smashed with a hammer flat, so that its both sides of the expansion of the increase and then fastening, but can not be disassembled many times, until the next maintenance repair.

4. Damaged oil tank. Motor vehicles in use, found that the oil tank oil spill, can be wiped clean, with soap or bubble gum coated in the oil spill, temporarily blocked; Repair with epoxy resin adhesive, the effect is better.

5. Tubing rupture. When the tubing ruptures, clean the ruptured area, soap it, wrap a cloth or tape around the ruptured area, tie it tightly with wire, and then coat it with soap.

6. Broken tubing. When the tubing is broken, a rubber or plastic sleeve suitable for the tubing diameter can be found. If the socket is not tight enough, both ends are tied with wire to prevent oil leakage.

7, the cylinder head appears sandhole and oil leakage. Can be according to the size of the sandhole, choose the corresponding specifications of electrical fuse, hammer gently hit it into the sandhole, can eliminate oil leakage, water leakage.

8. Oil leakage from the oil pipe joint. When the motor vehicle is used, such as oil leakage in the oil pipe joint of the engine, it is mostly caused by the unsealing of the oil pipe horn and the oil pipe nut. Cotton yarn can be wrapped around the lower edge of the horn, and then tighten the tubing nut and the tubing joint. Can also chew bubble gum or maltose into a paste, coated in the oil pipe nut seat mouth, to dry coagulation after sealing.

9, the diaphragm or oil pump diaphragm rupture or fracture. The diaphragm can be removed from the detachable oil pump, and it can be sawed and filed into shape according to the original shape and size with bakerboard, electrical insulating bakerboard or plastic cloth, and then polished and mounted.

10, valve spring broken. After the valve spring is broken, the broken spring can be removed, the two sections of the broken in turn, can be used. Can also find a 1 mm thick sheet metal, cut into 1 mm greater than the spring diameter wafer, internal cut a round hole, the diameter is less than the spring diameter of 4 mm, outside edge every 6 mm cut into 4 mm long gap, after been cut every one slice of a groove, forming double spring seat will spring back into the tin slot can be used again.

For knowledge of oil return pipe aluminum pad, please consult north dragon internal combustion engine accessories